Site Overlay


Once the batteries are charged, the CH, with batteries in place, can be clipped to your belt and then connected directly to a Canon Digital Camcorder. Due to impact or excessive pressure on the mic, this assembly can deform or break. A different battery or AC power source. Took a chance on Video One Repair. The internal contacts on your headphone jack wear out or the plastic around the contacts break. A small, light and powerful video light for indoor and outdoor use.

Uploader: Zuzilkree
Date Added: 8 March 2018
File Size: 68.94 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 30624
Price: Free* [*Free Regsitration Required]

Even if the camera has just a few hours on it, it’s cheaper to change everything rather than spend the time aligning a new path. I’m trying each camera separately. Drivers Software Firmware Utilities Loading Also please exercise your best judgment when posting in the forums–revealing personal information such as your e-mail address, telephone number, and address is not recommended. We have also seen many situations where there has been excessive moisture or rain that has gotten into the camcorder.

Sexually explicit or offensive language Spam: Please try again now or at a later time. Due to impact or excessive pressure on the mic, this assembly can deform or break. I’m guessing that it would capture as “uncompressed” footage and require a ridiculous amount of throughput, even canoh the footage has fiewire HDV compression already Am I setting the Canon right? Also, is it possible to capture component out via an intensity pro from an HDV tape?


These problems can be caused by various parts of the camcorder. So, if another unrelated problem occurs within 6 months, just send it back in and we will take care of it for you — no charge! The experience I had was moving the camera from one computer to another and then testing with a second camera, and a third computer.

It’s perfectly normal and nothing is malfunctioning. The 9-pin is reserved for firewirebut I’m unable to edit my post. If after thoroughly testing your camcorder all checks fine, you may continue using it however you may want to be cautious and always have a backup with you in case it fails. Canon USA shall have no responsibility under this limited warranty for use of the Equipment in conjunction with incompatible peripheral equipment and incompatible software.

I hope this helps anyone out there in the same boat, beacuse I haven’t read any forum posts that says to daisy chain external hard drives to your computer and camera fifewire make it work, but this is the only solution I dha1 able find myself. For the record, I was not the only one who had this issue as noted herehereherehereherehereherehereand many more.

Be very careful as to not allow these flexible ribbon circuit boards to short out.

XH-A1 Firewire Problems

These uses are covered only by such specific warranty as Canon may issue with such sales. Check the FireWire settings on your camcorder. Once an estimate is approved we repair or replace the part or parts of the mechanical transport that are causing problems. The first thing to try is remove all power from the camcorder, and then reapply power back on the camera.


If the headphone jack feels loose or broken then unfortunately it will need to be replaced. The exposed wiring may short the internal circuitry of the camcorder and cause more damage.

Transferring video recordings to and from a computer XH A1S and XH G1S

We have a blog article that goes over how to safely connect the DV Firewire cable from your XHA1 to the computer to avoid damaging the firewire connector port or the internal circuitry in your XHA1: These are the options I DO have: These circuits send many different and specific voltages to various parts of the camcorder. There are typically no cirewire drops that are the same.

These tiny white specks are known as dead, missing, hot, or stuck pixels. That means it must be an issue with Premiere not being able to capture in HDV. Enter your search terms Submit search form.

Is this the wrong cable?